Rebuilt Clutch Pressure Plate for Allis Chalmers WD45 Tractors, 70230424 The pto shaft turns freely

The pto shaft turns freely

Bracket shaft diameter is 1/2" inch

one clip (1) per LEFT and RIGHT sides

There are multiple sizes of inner rear axle bearing for these tractors

Please check your crankshaft casting number before ordering to ensure you receive the correct part

Rebuilt Clutch Pressure Plate for Allis Chalmers WD45 Tractors, 70230424 The pto shaft turns freelyRebuilt Clutch Pressure Plate for Allis Chalmers WD45 Tractors with serial number 99648 and above. Rebuilt by NeilCo in Columbia, South Carolina. 10" Inch Clutch Pressure Plate. Single stage clutch with 3 fingers and 9 coil springs. Clutch flywheel step is 1. 188" inch. Please measure your pressure plate and compare to listing photos before ordering as some tractors had multiple types of clutches. Clutch was rebuilt in the 1980's. Clutch pressure